實體環境設定
Extreme X430 的 Port 22,24 要連到 HP 2610 的 Port 5,6
Extreme:
#enable sharing 24 grouping 22, 24 algorithm address-based L2 lacp
HP:
#configure terminal
#trunk 5-6 trk1 lacp
#vlan XXX
#untag trk1
設定完成後
Extreme:
#show lacp
LACP Up : Yes
LACP Enabled : Yes
System MAC : 00:04:96:xx:xx:xx
LACP PDUs dropped on non-LACP ports : 1500
Lag Actor Actor Partner Partner Partner Agg
Sys-Pri Key MAC Sys-Pri Key Count
--------------------------------------------------------------------------------
24 0 0x0400 00:1f:28:xx:xx:xx 60032 0x0035 2
================================================================================
# show sharing
Load Sharing Monitor
Config Current Agg Ld Share Ld Share Agg Link Link Up
Master Master Control Algorithm Group Mbr State Transitions
==============================================================================
24 22 LACP L2 22 Y A 23
L2 24 Y A 20
==============================================================================
Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback
Load Sharing Algorithm: (L2) Layer 2 address based, (L3) Layer 3 address based
(L3_L4) Layer 3 address and Layer 4 port based
Number of load sharing trunks: 1
HP:
# show lacp
LACP
PORT LACP TRUNK PORT LACP LACP
NUMB ENABLED GROUP STATUS PARTNER STATUS
---- ------- ------- ------- ------- -------
5 Active Trk1 Up Yes Success
6 Active Trk1 Up Yes Success
#show trunks
Load Balancing
Port | Name Type | Group Type
---- + -------------------------------- --------- + ----- -----
5 | 4F6(409) 10/100TX | Trk1 LACP
6 | 4F5(403) 10/100TX | Trk1 LACP
# show vlans ports trk1
Status and Counters - VLAN Information - for ports Trk1
VLAN ID Name | Status Voice Jumbo
------- -------------------- + ---------- ----- -----
XXX V_XXX | Port-based No No
沒有留言:
張貼留言